5
6.
7.
8.
9.
10.
11.
E. Cutting the Feed Hose - (cont.)
When cutting hoses, please use strong
scissors or a sharp knife. Be sure to slide
the floats out of the way when cutting hose.
Put extra mender nut on the Legend® mast
and push clear hose gently over mast at
1/2", turn mender nut around clear hose
tight. Note: The Back-Up Valve still should
be 20" from the head of the cleaner.
Now take the bag, EU16, out of the box and
firmly twist lock bag onto the top of Legend®
throat over rubber debris valve.
Review and check list:
White and clear
hoses cut properly and floats evenly spaced.
Mender nuts tight around swivels, Back-Up
Valve, Legend® mast and wall fitting. Make
sure wall fitting is securely locked into place.
Lower your complete Legend® assembly
into your pool carefully. It should look like
figure below.
Go back to your equipment and turn filter
pump on first (wait 30 seconds to force air
out of the hose),
then turn booster pump
on.
12.
For adding additional feeder hose for large
pools requiring more hose length you will
need to purchase one (1) additional hose
(ED45), four (4) floats (ED10P), one (1)
swivel (ED05), and two (2) mender nuts
(ED15). Attach extra white hose between
clear hose and existing white hose, using
floats, swivel and mender nuts.
Divide
extra white hose overage by three (3) this
time to keep all white the same length.
LEGEND
®
INSTALLATION MANUAL
®
