AMERBRITE™ Color LED Pool Lamp Installation and User’s Guide
The following describes how to replace the Amerlite
®
Incandescent Lamp with the
“screw-in” AmerBrite™ Color Changing LED Lamp.
1.
Turn off main electrical switch or circuit breaker
, as well as the switch
which operates the underwater Amerlite incandescent lamp. Note: It is not
necessary to drain down the pool to replace the lamp.
2.
When replacing or reassembling the pool light assembly, the Gasket
(P/N 79101601) or Gasket and Lens (P/N 619864) which is included in
the AmerBrite Lamp kit must also be replaced. See page 11 for part
numbers.
Before starting make sure that you have the AmerBrite color pool lamp
assembly (12 VAC P/N 602060, or 120 VAC P/N 602065) ready to install.
3.
Remove the Amerlite incandescent light assembly
: Remove the PILOT screw
at top of face ring, then remove the light assembly from the niche by tilting the
top away from the niche and then lifting the light assembly from the locking tab
at the bottom of the niche.
4.
Place the light assembly on the pool deck.
5.
Place a cloth on the ground. Turn the light over so the lens is resting on the
cloth. Using a 3/8" nut driver or #3 Phillips screwdriver and a 7/16" wrench,
remove the nut and uni-tension wire clamp.
6.
Remove the face ring from wire clamp from the light housing.
7.
With the light resting on its base, carefully pry off the gasket to remove the
lens.
8.
Unscrew and remove the Amerlite lamp.
9.
Discard the uni-tension wire clamp.
10. Inspect the inside of the Amerlite light housing. Be sure the inside is clean
and dry.
11. Discard the lens, gasket and Amerlite lamp.
12. Using a clean dry cloth, thoroughly wipe the inside of the light housing. Be sure
the light housing is clean and dry. Residual moisture and humidity inside the
light housing may reduce the life of the AmerBrite lamp LED assembly.
AMERBRITE™ COLOR LAMP INSTALLATION INSTRUCTIONS
(CONTINUED)
6
Lock
lever
Uni-tension
7/16” nut
and bolt
