AMERBRITE™ Color LED Pool Lamp Installation and User’s Guide
7
13.
Install the “Screw-in” AmerBrite™ Color LED Lamp (120 VAC or 12 VAC):
Insert the threaded end of the AmerBrite lamp stem assembly into the lamp
socket. Rotate the stem assembly to secure it into the socket. Do not over
tighten.
14. While holding the AmerBrite LED Lamp assembly, route the lamp power cord
connector through the hole in the top of the LED assembly.
15. Install the assembly onto the light housing. Carefully align the "TOP" indicator
arrow on the LED assembly with the "TOP" indicator on the Amerlite
®
Stainless
Steel Light housing. Be sure the LED assembly is level with the lamp housing.
CAUTION: If the LED assembly is not level, the LED assembly may interfere
with the lens installation and/or have improper lighting performance.
16. Connect the lamp power cord plug to the LED assembly socket.
17. Install the torque-limiting nut onto the top of the stem. Rotate the top section of
the torque-limiting nut until it continues to “click” with each rotation (similar to a
car gas cap), this indicates the nut is secured in place.
Lamp Stem assembly
Threaded end of
light stem
Lamp socket (inside
niche)
Route light power
cord connector
through the hole in
LED assembly
Connect light
power cord
plug to LED
assembly
socket
Stem
▼
▼
Torque-
limiting
nut
installed
Rotate
Torque-
limiting
nut
(120 VAC AmerBrite Color
LED Lamp shown)
