AMERBRITE™ Color LED Pool Lamp Installation and User’s Guide
Selecting a AmerBrite Light Show Mode or Fixed Color using a
Wall Switch
AmerBrite color lamps are compatible with IntelliBrite light colors and shows and can be
synchronized with IntelliBrite color lights.
First switch power on to the light, the previously selected color is displayed. To select a
color show mode (1-7) or fixed color
(8-12), turn the wall switch off/on a specific number of times. Each number (1-12) shown
below corresponds to the number of times to power-cycle the switch to activate a color
light show or fixed color. For details about saving color effects while in “show” modes,
see “Hold” and “Recall” feature on page 3.
1
SAm Mode:
Cycles through white, magenta, blue and green colors
(emulates the Pentair
®
SAm
®
Color Changing Light).
2
Party Mode:
Rapid color changing building energy and excitement.
3
Romance Mode:
Slow color transitions creating a mesmerizing and
calming effect.
4
Caribbean Mode:
Transitions between a variety of blues and greens.
5
American Mode:
Patriotic red, white and blue transition.
6
California Sunset Mode:
Dramatic transitions of orange, red and
magenta tones.
7
Royal Mode:
Richer, deeper color tones.
8
Blue:
Fixed color.
9
Green:
Fixed color.
10 Red:
Fixed color.
11 White:
Fixed color.
12 Magenta:
Fixed color.
13 Hold:
Save the current color effect during a color light show.
14 Recall:
Activate the last saved color effect.
AmerBrite
™
Color Lamps can be controlled using a standard wall-mount light switch or
by the IntelliBrite
®
Color Light Controller (see page 3). Multiple AmerBrite lamps can be
connected via a junction box to a single switch so that all lights can be switched on and
off together. AmerBrite lamps are controlled by cycling AC power from a standard wall
switch. By turning the switch on and off a specific number of times, the light activates one
of the seven light show modes, fixed colors, or enables the “Hold” and “Recall” feature.
Powering on the AmerBrite Color Lamps
When the AmerBrite lamp is powered on, the previously selected color is displayed.
Note
: If power to the lamp is off for more than five (5) seconds, the last color show mode
or fixed color that was saved will be displayed.
Operating AmerBrite
™
Color Lamps Using a Wall Switch
Note:
When the AmerBrite lamps are powered on, the previously selected
color will be displayed, unless the HOLD or RECALL feature was
previously enabled.
2
Number
of
times
to
cycle
power
(1-14)