AMERBRITE™ Color LED Pool Lamp Installation and User’s Guide
3
Example:
To select
California Sunset Mode
; turn the light on, then turn off and on six
times. During the off/on switching process, no illumination will occur,
Saving a Color Mode or Fixed Color
When power is switched off to the AmerBrite
™
Color Lights, the last color show mode or
fixed color will be saved. The next time the light is powered on, the previously saved
color show mode or fixed color will be displayed. For example, while in “Party Mode”
switch the light off. Wait more than 10 seconds, switch the light back on to resume “Party
Mode.”
Instead of using a wall switch, AmerBrite lamps can
be controlled with the IntelliBrite Controller
(p/n 600054), sold separately. The IntelliBrite
Controller provides complete control of your
AmerBrite lamps. It’s easy to select a lighting
feature, just dial in any one of the pre-programmed
color light shows or fixed colors. Using the Hold and
Recall buttons you can also create special lighting
effects. The IntelliBrite Controller can control
individual or multiple AmerBrite lamps. Multiple
AmerBrite lamps can be connected via a junction
box to the Controller so that all lights can be
switched on and off together. The IntelliBrite Controller can also control multiple
AmerBrite lamps and IntelliBrite Lights.
Selecting a AmerBrite Light Color and Show Modes or Fixed
Color Using an IntelliBrite
®
Controller
Using the IntelliBrite
Color Light Controller:
AmerBrite lights are compatible with
IntelliBrite light colors and shows and can be synchronized with IntelliBrite color pool/spa
and landscape lights. To select a color light show mode or fixed color mode, rotate the
dial so that it points to the desired selection. The color mode selections start in a
clockwise direction from the 9 o’clock position (see page 2).
Hold and Recall Feature
Note:
When AmerBrite lights are powered on, the previously selected color will be
displayed, unless the HOLD or RECALL feature was previously enabled.
Hold button/LED:
Press this button (LED on) to capture and save a color effect while
displaying one of the light show modes. When the button is pressed, the LED will be on,
indicating that the color effect is captured.
Recall Button/LED:
Use this button (LED on) to activate the last saved color effect. When
the button is pressed, the LED will be on, indicating that the color effect is being
displayed.
During the off/on switching process, before the selected color is displayed, no
illumination will occur for a brief second. This operating mode is normal during the
switching process. During this period the pool and spa will be dark and precautions
should be taken to avoid unforeseen accidents. Failure to observe this warning may
result in serious injury or death to anyone in or around the pool or spa.
