Installer Manual Performa 263-268 / LOGIX 740-760 - Description
Ref. MKT-IM-011 / A - 15.06.2017
13 / 64
3.4.
Options available on the valve
3.4.1. Chlorine generator (check salt light)
The Logix 740 and 760 controllers have the capability to produce a low level of chlorine to chlorinate
the resin bed during regeneration. A check salt light will indicate when the user needs to add salt to
the brine tank. Potassium chloride or sodium chloride may be used.
No.
Operation
A
Unplug the wall-mounted transformer.
B
Shut off water supply or put bypass valve(s) into bypass position.
C
Relieve system pressure before performing any operations.
D
Unlock the cover (
2
) from the slide clips (
1
) (one on each side of the valve).
E
Remove the controller (
3
) by pressing on (
4
).
F
Connect the small chlorine generator connector to the back of the controller (
5
).
G
Remove the existing refill controller (
6
) with the ball (
7
) from the valve and replace it with
the one provided in the kit.
H
Connect the other end of the cable to the refill controller previously installed.
Connect firmly to ensure a good contact.
I
Reverse above procedure steps to rebuild.
Note
No programming is necessary for the chlorine generator to work properly on the controller.
The system will be automatically functional after the chlorine generation senses brine for
the first time. There is a check salt light on the front of the controller that will illuminate
when there is no brine present during the brine draw.
Chlorine generator
(check salt light)
A
