COLORCASCADE
®
Color Pool and Spa Light Installation and User’s Guide
COLORCASCADE
®
Color Pool and Spa Light Installation and User’s Guide
Selecting a ColorCascade light show mode or fixed color using
a Wall Switch
ColorCascade lights are compatible with IntelliBrite light colors and shows and can be
synchronized with IntelliBrite
®
lights. First switch power on to the light; the previously
selected color is displayed, unless the HOLD or RECALL feature was previously enabled..
To select a color show mode (1-7) or fixed color (8-12), turn the wall switch Off/On a
specific number of times. Each number (1-17) shown below corresponds to the number
of times to power-cycle the switch to activate a color light show or fixed color. For details
about saving color effects while in Show modes, see “Hold” and “Recall” feature on page 6.
1
SAm Mode:
Cycles through white, magenta, blue and green colors
(emulates the Pentair SAm® Color Light).
2 Party Mode:
Rapid color changing building energy and excitement.
3 Romance Mode:
Slow color transitions creating a mesmerizing and
calming effect.
4 Caribbean Mode:
Transitions between a variety of blues and greens.
5 American Mode:
Patriotic red, white and blue transition.
6 California Sunset Mode:
Dramatic transitions of orange, red and
magenta tones.
7 Royal Mode:
Richer, deeper color tones.
8 Blue:
Fixed color.
9 Green:
Fixed color.
10 Red:
Fixed color.
11 White:
Fixed color.
12 Magenta:
Fixed color.
13 Hold:
Save the current color effect during a color light show.
14 Recall:
Activate the last saved color effect.
15
White
16
Standard Mode
17
IntelliBrite Mode
ColorCascade Lights can be controlled using a standard wall-mount light switch or by the
IntelliBrite
®
Controller (see page 3). Multiple ColorCascade lights can be connected via a
junction box and 12 VAC transformer to a single switch so that all lights can be switched
on and off together. ColorCascade lights are controlled by cycling AC power to the 12
VAC transformer from a standard wall switch. By turning the switch Off and On a specific
number of times, the light activates one of the seven light show modes, fixed colors, or
enables the “Hold” and “Recall” feature, see page 6.
Powering on the ColorCascade Light
When the ColorCascade light is powered on, the previously selected color is
displayed, unless the HOLD or RECALL feature was previously enabled.
Note: If power to the light is off for more than five (5) seconds, the last color show
mode or fixed color that was saved will be displayed.
Operating ColorCascade
®
Color Lights Using a Wall Switch
Number of times to cycle power (1-17)
3
