P/N
520044
4
Rev. C 10-31-02
SECTION VIII. RECONFIGURING FUNCTIONS ON THE HAND-HELD REMOTE
There are 4-qty 4-position configuration switches (designated SW1, SW2, SW3 and SW4) located on the
Receiver circuit board. These switches are used to configure the four buttons on the Hand-held Remote:
SW1 will configure Spa Button (of the Hand-held Remote).
SW2 will configure “A” Button (of the Hand-held Remote).
SW3 will configure “B” Button (of the Hand-held Remote).
SW4 will configure “C” Button (of the Hand-held Remote).
Each 4-position switch can be reconfigured to activate any circuit on the Control System. Use a paper clip or
other blunt instrument to slide the appropriate switch to the "ON" or “OFF” position, in accordance with the
diagram below.
