Pentair i-Link, User Manual

IntelliTouch i-Link Protocol Interface Adapter User’s Guide

Special COMMAND Only commands for: IntelliBrite LED Lights and

MagicStream Laminars

The following lighting commands support IntelliBrite LED lights and MagicStream
laminars. For more information, also see COLORSYNC, COLORSET, and
COLORSWIM commands (see page 15).  The following commands for the
IntelliBrite LED light and the MagicStream Laminar are as follows:

Note:  The following commands require i-Link version 1.021 or higher. The
MagicStream laminar commands for Random, Sync, and Party require IntelliTouch
outdoor control panel version 1.132 or higher.

COLORSWIM:

Colored Lights Control

COLORSET:
COLORSYNC:

Send Command:
Command:

#COLORSET <cr>

Response:

!00 COLORSET = 1<cr>

(RSPFMT = 0)

!00 1<cr>

(RSPFMT = 1)

Note:

The above color commands only operate lights configured in the special

IntelliTouch "Lights" screen.

Sam, Sal, PG2000 Fiber Optic lights and IntelliBrite LED lights

The following commands support the Sam, Sal, PG2000 Fiber Optic Unit and
IntelliBrite LED light.
These commands 

do not support

 the MagicStream laminar.

COLORSWIM:

Start a Color Swim Sequence

COLORSET:

Set Lights to pre-selected Colors

COLORSYNC:

Synchronize All Color Lights

The following commands 

only support

 the IntelliBrite LED lights.

IB_PARTY

Set ALL IntelliBrite Units to PARTY mode

IB_ROMANCE

Set ALL IntelliBrite Units to ROMANCE mode

IB_CARIBBEAN

Set ALL IntelliBrite Units to CARIBBEAN mode

IB_AMERICAN

Set ALL IntelliBrite Units to AMERICAN mode

IB_SUNSET

Set ALL IntelliBrite Units to SUNSET mode

IB_ROYALTY

Set ALL IntelliBrite Units to ROYALTY mode

IB_BLUE

Set ALL IntelliBrite Units to BLUE

IB_GREEN

Set ALL IntelliBrite Units to GREEN

IB_RED

Set ALL IntelliBrite Units to RED

IB_WHITE

Set ALL IntelliBrite Units to WHITE

IB_MAGENTA

Set ALL IntelliBrite Units to MAGENTA

IB_HOLD

Command ALL IntelliBrite Units to Hold/Stop/Freeze

IB_RECALL

Command ALL IntelliBrite Units to Recall last setting

The following commands 

only support

 MagicStream laminars:

MS_THUMPER

Toggle ALL MagicStream Thumpers ON or OFF

MS_HOLD

Command ALL MagicStream Units to Hold/Stop/Freeze

MS_RESET

Reset ALL MagicStream units

MS_MODE

Toggle Mode on ALL MagicStream Units  Random,
Party, Sync

MS_SYNC

Set ALL MagicStream units to SYNC Mode

MS_RANDOM

Set ALL MagicStream units to RANDOM Mode

MS_PARTY

Set ALL MagicStream units to PARTY Mode

14