8
9.
INSTALLING THE INTELLIBRITE
®
LED LIGHT WITH NEW GASKET:
Install a new gasket (P/N 79101600)
during reassembly of the IntelliBrite LED light. A NEW LENS GASKET MUST BE USED EACH TIME THE
LIGHT IS REASSEMBLED.
10.
Clean the inside surface containing the four mounting studs with isopropyl alcohol. Be sure to keep the
underside of the new IntelliBrite
®
LED assembly clean.
11. Connect the IntelliBrite
®
LED light plug to the connector in the light housing. Lower the LED light assembly into
the light housing. Be sure that there are no wires caught between the housing and the back of the light
assembly.
12. Orientate the light assembly so that the word “
Pentair
” on the circuit board is positioned at the top (where cable
exits) as shown below.
13. With the housing resting on its base, carefully align the four screws holes of the light assembly and the housing
base. Using a ¼" nut driver, secure the light assembly in place with the four (4) retaining nuts.
14.
Install the new gasket onto the lens:
a
) With the light housing resting on its base, place the
lens then the gasket on top of the light housing.
b
) Place the face ring on top of the gasket. Make sure
that the lens and gasket are centered correctly on the
light housing.
c
)
Aligning the face ring and lens:
Align the face ring
and lens so that the letter “O” in the word “TOP” (and the
small arrow above it) on the surface of the lens points to
the pilot screw hole on the face ring.
d
)
Aligning the lens position with the LEDs:
While
looking through the front of the lens, slightly rotate the
lens until the vertical lines on the lens are in focus with
the four (4) rows of LEDs below.
Clean this
surface before
installing the
light assembly
Retaining nut
(4x)
The word “
Pentair
”
on the circuit board
is positioned at the
top
Top of light housing
where cable exits
Cable
T O P
▲
Align vertical line
on lens with rows
of LEDs under
lens
Align letter “O” in
the word “TOP”
on lens with pilot
screw hole on
face ring
