JET-VAC INSTALLATION MANUAL
8
1. Turn off booster pump, filter pump and time clocks.
2. Attach the wall fitting to the pool wall.
3. Attach the "Sweep Hose" end of the feed hose to the wall
fitting. (Hereafter,
attached refers to attached to the wall fitting).
See Photo #1.
4. With a loose grasp on the feed hose, walk around the
circumference of the pool to find the point that is furthest from
the wall fitting and remove slack from the hose,
but do not
stretch the hose. See Photo #2.
5. While maintaining a grasp on the attached hose, use a sharp
knife to cut the dark blue hose (marked with a bright-colored
label reading "cut this section only") at the point where the end
of the hose would touch the edge of the pool. See Photo #3.
Take both hose sections and go to the wall fitting.
*Note: After you cut the dark blue hose to size, evenly space
the two ED10P floats moving them so they divide the
remaining section into three equal parts.
6. Secure with your foot or knee the dark blue attached hose.
Remove the dark blue piece of hose from the white section at
the mender nut and discard the severed piece of dark blue
hose.
7. At the mender nut, attach the removed white hose to the
severed end of the attached dark blue hose. See Photo #4.
8. Reverse hose ends (disconnect the sweep hose end of the
hose from the wall fitting and reconnect the other white hose
end to the wall fitting).
HERE IS JET-VAC’S SIMPLE, TIME SAVING AND INNOVATIVE
APPROACH TO QUICK AND EASY INSTALLATION!
Photo #1
Photo #2
Photo #3
Photo #4
