1
SandShark
™
Installation and User’s Guide
Section 1
Pool Preparation
Pool Cleaner
Guage
Hose Weights
Eyeball
Reducer
Cone
Vac Port Fitting
Regulator
Cap
Regulator
The following general information describes how to set-up your new SandShark
™
automatic pool cleaner.
NOTE: Before setting up this product, read and follow all warning notices and instructions starting
on page ii.
Preparation of your pool
Before you assemble and install your new SandShark
™
automatic pool cleaner, you should make sure that
your pool is clean and free of algae. If necessary, make the following preparations before proceeding
:
•
Chemically balance the pool water
•
Brush the pool and let the debris settle
•
Hand vacuum the pool thoroughly
•
Backwash and clean the filter and clean the pump
strainer basket, (see Figure 1)
Cleaner Assembly
Check Parts
Remove the Cleaner and all of its parts from the box and
check to make sure that all components were included,
(see Figure 2).
■
Pool Cleaner
■
Short Leader Hose
(1 Length, 12 inches)
■
Hose (10 Lengths, 40 inches)
■
Hose Weights (2)
■
Eyeball diverters (2)
■
Reducer Cone
■
Vac Port Fitting
■
Regulator
■
Regulator Cap
■
Flow Gauge
Skimmer
Basket
Pump
Strainer
Figure 2.
Figure 1.
Summary of Contents for Kreepy Krauly SandShark 7900
Page 22: ...16 SandShark Installation and User s Guide NOTES...
Page 23: ...SandShark...
Page 24: ...P N 39503 6300 Rev A 10 27 08...