MicroBrite® light overview
This manual describes how to install, replace and operate the 12 VAC MicroBrite light for pool and spa.
The MicroBrite light provides exceptional brilliance and lighting uniformity. For new pool and spa designs,
their compact size delivers the freedom to add dynamic lighting in places never before possible. Let your
imagination take you to brighter places!
MicroBrite® light wiring installation
To connect the MicroBrite light to a junction box:
1 - Route the MicroBrite light power cord light cable through the wall fitting to the location of the junction
box.
2 - At the junction box, leave at least 15 cm of cord to facilitate the light installation. Cut off any extra cord.
WARNING :
Electrical wiring to the lighting must be in accordance with the latest edition of the Electrician
Wiring Rules (see p1).
3 - Connect the two (2) conductors to the corresponding circuit wires in the junction box. Secure the junction
box cover.
4 - Before operating the MicroBrite light, fill the pool with water until the light is completely submerged.
Note: The MicroBrite white light should not be powered for more than 30 seconds if is not submerged in
water.
5 - Final check for proper MicroBrite light operation:
Switch on the main switch or circuit breaker to the 12 VAC transformer and the switch that operates the
MicroBrite light itself. The light should illuminate when the 12 VAC power is applied. If not recheck the
installation steps.
GLOBAL WIRING INSTALLATION RULES
GLOBAL PRESENTATION
3