14
I ©2019 Pentair plc.
Installation Notes:
Date Installed: ___________________________________________________________________
Serial No. (Spec Label): ___________________________________________________________
Installer: ________________________________________________________________________
Phone: __________________________________________________________________________
Location of Installation: __________________________________________________________
Pump Model No: _________________________________________________________________
Motor: HP, Vac, Ph, SF Amps ______________________________________________________
Static Depth: (m/ft) _______________________________________________________________
Flow Rate: (lpd/gpd) ______________________________________________________________
PV Panel Manufacturer/Model Number: ____________________________________________
No. of Solar PV Panels in Series: ___________________________________________________
Note to Installer:
Record the data listed above along with DIP switch setting for future
reference. Give manual to end user or attach to Pentair Pentek Solar Drive when
installation is complete.
Maintenance:
The Pentair Pentek Solar Drive is designed to operate autonomously, however it is
suggested to be inspected every 3 months. If there are any external obstructions that
prevent proper cooling of the heat sink, please remove them to make sure nothing blocks
the air flow from the bottom of the device.
If the Pentair Pentek Solar Drive will operate in a location where freezing temperatures
may occur, deactivate the system with the DC Disconnect during these conditions.
This will prevent the pump from potentially dead heading against a frozen pipe.
Check external sensors every 3 months: float switch, pressure switch, etc.