POOLSHARK
™
Automatic Vacuum Pool Cleaner Installation & User’s Guide
10
MAINTENANCE
1. With a screwdriver, carefully work the rubber
vacuum pad down over the lip of the Outer Housing,
(see Figure 18).
2. Lift the Outer Housing straight up off of the chassis.
Squeeze the tabs on the Bumper/Height Limiter
Clips (inside the housing) to remove the Bumper
Height Limiter. The Bumper/Height Limiter,
Bumper/Height Limiter Boots, and Bumper/Height
Limiter Clips pull apart, (see Figure 19).
3. Squeeze and pull the Sprocket Clips to release the
Drive Shaft Assembly and Center Sprocket, (see
Figure 20).
4. Pull the Oscillator Straight out from the bottom of
the Outer Housing. Be careful not to lose the Sliding
Seals, (see Figure 21).
5. Squeeze the latching tabs and pull up on the Swivel
Housing and Swivel. The assembly will come up,
releasing the Swivel Sprocket. Squeeze the latching
tabs to remove the Clutch Clip, (see Figure 22).
6. Remove the Shaft Plug with the stainless steel shaft
and the Large Steering Drive Assembly, (see Figure
23).
7. Remove the Oscillator Sleeve, releasing the
Oscillator Sleeve Bushing and the Clutch assembly,
(see Figure 24).
Disassembly
Reassembly
To reassemble the PoolShark
™
, reverse the steps above.
NOTE:
The notch on the center disk of the Large Steering
Drive Assembly must be down (as shown in Figure 25) for
assembly.
Figure 18
Figure 19
Figure 20
Figure 21
Figure 22
Figure 23
Figure 24
Figure 25
