9
OPERATING INSTRUCTIONS FOR THE DIGITAL 90 SECOND TIMER
AND SETTING FOR EXTERNAL TIMER OPERATION
Up & Down
arrow Buttons
Red “ON”
LED
LED Time
Display
Continuous
Run (C-RUN)
Button
OPT Button
OP T
C- RU N
FORWARD / REVERSE TIMED MOVEMENTS:
You may control the length of the forward / reverse
movement time of your cleaner by using the control
pad on your Power Supply. The optimal amount of
seconds to set the forward / reverse movements is
the amount of time for cleaner to move to the furthest
points of your pool, (cleaner can no longer move
forward) plus several seconds to rest before reversing.
The timer automatically recalls your setting once
movement time is set.
To Adjust Time:
Press the Up facing Arrow Button
once for each additional second of movement you
desire (up to 90 seconds) or the Down facing Button
for less sec-onds (down to one second).
NOTE: As the cleaner moves across the pool, dirt can
accumulate in the fi lter bag, reduce water fl ow and slow
movement. Several seconds are needed in your setting to
allow enough time for your cleaner to reach the furthest
point of the pool before reversing. Any additional seconds
added while cleaner is operating are saved and automatically
recalled with each subsequent use.
SET TIME:
1. Turn the Power Supply Power Switch to
the “ON” position.
2. Adjust the timer (from 1-90 seconds).
3. Press either the OPT Button or C-RUN.
Turn the Power Supply ON and wait a few seconds until the LED Ught fl ashes two horizontal bars in the LED Time
Display. Make sure the GREEN light above the C-RUN Button is not blinking. If light is blinking, the timer is already
set to the ExternalTimer Mode. If time is not blinking, it is currently set to the Internal 2·Hour Automatic Shut Off Timer
Mode. Reset the Power Supply to the External Timer Mode by doing the following:
1. Press and release the C-RUN Button once. GREEN Light will illuminate.
2. Press and hold the C-RUN Button for approximately 5 seconds until the GREEN Light blinks. If blinking, the timer to
the External Timer Mode is set.
Note: Power Supply will remain in the External Timer Mode until you physically reset it to the Internal Timer Mode;
your 1 to 90 second Forward / Reverse digital time setting will not be affected. It will not reset to the Internal Timer
Mode even if the power to the Power Supply is set to the OFF position.
Prowler
®
710 Installation and User’s Guide
OPT Button
Ideal setting for frequent cleaner use. In this setting your cleaner will Continuously Run until either the Power
Supply is turned OFF or the Power Supply ‘ON / OFF Button’ is pressed “OFF” manually. To restart your cleaner,
either manually press the Power Supply ON / OFF Button or if Power Supply is connected to an external [separately
purchased] automatic time control power source*, you can operate cleaner in the External Timed Mode.
*Traditional external automatic time control power sources can be found at electrical and home renovation stores. Pool
equipment specifc time control systems (control the cleaner’s Power Supply via a dedicated ‘relay’ connection) can be
found at your pool retailer / builder.
C-RUN Button
Optimal setting for occasional cleaning. Cleaner will automatically turn off after 2 Hours of operation.
ExtemalTimer Mode Set-Up:
Summary of Contents for Prowler 710
