Rev. A 7-25-03
5
P/N 520209
SECTION VI. CUSTOMIZING THE COMMUNICATION LINK
The communication link between the Receiver and Hand-held Remote can be customized to prevent electrical
interference. To accomplish this, there is a 10-position configuration switch located on the Receiver circuit board,
and inside the Hand-held Remote. Units are shipped from the factory with all switches in the ON position.
If you wish to change this setting, use a paper clip or other blunt instrument and adjust both 10-position
configuration switches to matching settings. If the configuration switch setting at the Receiver does not match that
of the Hand-held Remote the communication link will not function.
If the IntelliTouch system has not been set to a new house address you should do so now. To set a new House
Address consult the main system instructions. The Load Center System Control lights will blink repeatedly when
a house address is being sent out.
If the system is sending a new house address, the COM LINK and COMMAND lights will blink together
repeatedly on the QT4 board.
If the system is sending an existing house address, the COM LINK and COMMAND lights will blink alternately.
While this is happening press any button of the Hand-held Remote. The COM LINK and COMMAND lights will
blink alternately. The main system may now be RESET. Wait for Auto Mode and the QT4 lights to stop blinking
before resuming normal operation.
SECTION VII. HAND-HELD REMOTE BATTERY REPLACEMENT
With normal use the battery should last for several years. In the event the battery must be replaced, slide the cover
from the bottom of the Hand-held Remote. Slide the battery from the retainer clip and discard in accordance with
local and/or state ordinances. Replace with 3V lithium battery number CR2032 or equivalent. Slide battery cover
onto remote and snap in place.
Receiver
Hand-held Remote
Switch
NOTE: All Program Switches are Factory set to “ON”.
Battery
Compartment
COM LINK
Light
COMMAND
Light
