9 / 12
THERMAL MANAGEMENT SOLUTIONS
EN-RaychemWinterGardH900-IM-H53665 01/13
1/4 in
1/4 in
1/2 in
1/2 in
1/4 in
4
6
8
9b
5
7
9A
• Notch core at end.
• Twist back and peel bus wires
from core.
• Slide 5 1/2 in black
shrink tubes into
place against
conductive core.
• Shrink tubing by
moving heat source
continuously from
side to side.
• Center 1 in black shrink tube over end
of heating cable as shown.
• Heat tube evenly until it shrinks and
adhesive flows out both ends.
• Immediately pinch with pliers between
wires while tube is still hot. Hold for 10
seconds to ensure seal.
• Trim braid.
• Crimp ring terminal onto braid.
• Discard black grommet
supplied with sealing fitting.
• Slide parts onto heating cable
as shown.
• Score between bus wires at base jacket.
• Bend core to break free at base jacket.
• Peel core and any remaining material from bus wires.
• Slip green/yellow tube
over braid and shrink.
• Slide parts into position as shown.
Position flat side of
compression washer
against the blue
grommet.
cAUTION: Health Hazard.
consult material safety
datasheet RAy3122.
For H612 and H622 heating cables only
For H311, H611, and H621 heating cables only
