6
SX218 (03/09/20)
INSTALLATION
MOTOR/PUMP LIFTING PROCEDURE
Heavy parts.
NEVER walk or reach under a suspended
pump. DO NOT screw an eye bolt into the motor housing and attempt
to lift assembly!
The crane or hoist must have a capacity in excess of the combined
weight of the motor and pump. Use a minimum of two chains or
straps to lift motor/pump assembly, as shown below. Each chain or
strap must have a capacity in excess of the combined weight of the
motor and pump.
Wrap the first chain or strap under the fan end of the motor up tight
against the motor feet, and the second chain or strap under the pump
bracket between the pump end and the motor.
Raise motor/pump assembly slowly to ensure that the chains or
straps will not slip when put under tension. Balance motor and pump
with chains or straps to maintain proper weight distribution. If not
balanced, release tension on the chains or straps and readjust.
6545 0412
