45
Slide the setting switch back up to the (white
dot).
When you turn the camera on and press the
shutter release button halfway down, the
channel of the flash unit is registered on the
camera.
(Preparation of Separated Flash Unit)
Next, set the channel of the separated (wireless)
flash unit to the same channel as the flash unit
attached to the camera.
Place the other AF540FGZ in the desired
position.
Set the power switch of the flash unit to
(WIRELESS).
Press the wireless mode button (M/C/S) the
number of times required to display SLAVE on
the LCD panel.
Slide down the setting switch to the (yellow
dot) to display the channel on the LCD panel.
Press the channel button (CH) and select the
same channel that the flash unit attached to
the camera has been set to.
Slide the setting switch back up to the (white
dot).
●
The two flash units must be set to the same
channel, otherwise the separated flash unit will
not fire.
(Photographing)
Confirm that both flash units are fully charged,
and take the photograph.
A lamp on the wireless flash unit will blink.
2
3
00_AF540FGZ.book Page 45 Monday, April 10, 2006 11:42 AM
