234
Ap
pe
nd
ix
10
The Shake Reduction function operates by obtaining the lens information
such as focal length. Set the focal length when using a lens for which focal
length information cannot be automatically obtained.
1
Make sure that [Shake Reduction] is set to
Q
(On), and
turn the camera off.
Refer to “Taking Pictures Using the Shake Reduction Function” (p.100)
for details.
2
Attach a lens, and turn the camera on.
The [Input Focal Length] screen appears.
3
Use the e-dial to set the focal
length.
Select from the following focal length
values. (The default setting is 35 mm.)
4
Press the
4
button.
The camera is ready to take a picture.
Setting the Focal Length
8
10 12 15 18 20 24 28 30 35
40 45 50 55 65 70 75 85 100 120
135 150 180 200 250 300 350 400 450 500
550 600 700 800
• If the focal length for your lens is not listed above, select the value closest to
the actual focal length (example: [18] for 17 mm and [100] for 105 mm).
• When using a zoom lens, select the actual focal length at the zoom setting
being used in the same manner.
• To change the focal length setting, use [Input Focal Length] in the [
A
Rec.
Mode 2] menu.
• When using a lens without an
s
position on the aperture or with the aperture
set to a position other than
s
, set [16. Using Aperture Ring] in the [
A
Custom
Setting 3] menu to [Enable]. (p.235)
Input Focal Length
Input Focal Length
OK
OK
OK
Cancel
Cancel
MENU
30
30
40
40
35
35
Summary of Contents for K-01
