- Removal of original band:
1.
With the T-5 Torx driver remove all 4
screws from the backside of the FitBit
Surge that attach the band to the display
unit.
NOTE: The screws must be saved to
attach the band adapter (be careful and
work over the pan with edges to prevent
loss of screws)
Place 4 screws in a safe area for re-use in
later steps.
2.
Score the sides of the band (not top or
bottom) with a sharp knife (just cutting
the band) to make it easier to pry off.
Instructions for FitBit® Surge Band
replacement and installation of band adapter
- Preparation and Tools Required:
•
T-5 Torx bit Driver
(may be supplied
with product)
•
Pan with edge
(to keep
screws from getting lost during
disassembly/reassembly)
•
Knife
(for scoring)
(continued)
