Operator’s manual Pentruder
®
3P8 HF-wire saw and Pentpak - Original instructions
6
3
Safety instructions
Safety instructions which are used in this operator’s manual
Note!
This sign indicates technical specifics and methods which will facilitate the job.
!
Important!
Here we inform about risks connected with use of the machine, and, if the safety
precautions are not respected, can result in damage to property and persons in
close proximity to the machine.
WARNING!
Here we inform about risks connected with use of the machine, and, if the safety
precautions are not respected, can result in serious injury and even to fatal injuries
to persons in close proximity to the machine.
Intended use of the machine
It is of paramount importance that the operator has full knowledge and understanding of the Safety instructions.
This wire saw may not be used unless the operator is fully familiar with the contents of this Operator’s manual and has
been trained in its operation by an authorized distributor of Tractive AB’s products. If using a WRC Wireless Remote
Control, the operator must also be fully familiar with the contents of the Appendix for Wireless Remote Control:
Hetronic User’s Manual. The operator is fully responsible for the manner in which the machine is operated. It is the
responsibility of the purchaser that the operator has received the information needed to operate and handle the
machine in a safe a correct way.
Good working practice should always be used along with common sense. Tractive cannot foresee every possible
situation and this manual is not a substitute for professional skills and experience.
The Pentruder 3P8 HF-wire saw is intended to be used together with a Pentpak HF-power pack. The Pentruder 3P8
cannot be used with any other type of power pack. The Pentpak HF-power pack may only be used to power Pentruder
HF-machines.
The Pentruder 3P8 HF-wire saw may only be used for cutting of
•
Concrete
•
Stone material
•
Masonry
It is our expressed recommendation that the machine may only be used for cutting in these materials.
The base plate must be mounted on a stable structure, not on a mobile device.
Other use is non-intended and therefore to refrain from.
Always use a diamond wire suited for the power of the machine. Follow the diamond wire manufacturer’s
recommendations.
WARNING!
Do not use the machine for cutting other materials than listed or on loose masonry.
The safe fastening of the base plate cannot be guaranteed.
!
Important!
Please observe that Tractive’s responsibility as a manufacturer can only be accepted
when the wire saw, Pentruder 3P8, is used together with power packs and
accessories described in this Operator’s manual. If the machine is used with non-
original equipment the warranty and Tractive’s CE-marking will be void.
