PEP Modular Computers CP341, Manual

CP341

Installation

ID 18845, Rev. 0102

Page 3 - 4

® 

PEP Modular Computers GmbH

3.1.3

Board Installation

The CP341 is fully compatible with the plug & play philosophy.  As it uses standard Win-
dows NT drivers it does not need any jumper setting and, therefore, does not require
any hardware configuration. A complete set of drivers is located on the 

PEP Modular

Computers

 Driver disk supplied with the CP341.

However, if your system runs into an error message while booting, its configuration may
require additional steps. In this case, please refer to the 

readme.lst

 file on the Driver

disk.

3.1.4

Board Connection

To connect the CP341 Ethernet/Fast Ethernet adapter please simply insert the network
cable into the board’s RJ-45 socket. Then run the automatic configuration software and
install the network drivers,

Caution!

If your board type is not specifically qualified as hot-swap capable,
please switch off the CompactPCI system before installing the
board in a free CompactPCI slot. Failure to do so could endanger
your life/health and may damage your board or system.

$

$

Note:

Certain CompactPCI boards require bus master and/or rear I/O
capability. If you are in doubt whether such features are required
for the board you intend to install, please check your specific
board and/or system documentation to make sure your system is
provided with an appropriate free slot to insert the board.

ESD Equipment!

Your CompactPCI board contains electrostatically sensitive
devices. Please observe the necessary precautions to avoid dam-
age to your board:

•

Discharge your clothing before touching the assembly. Tools
must be discharged before use.

•

Do not touch components, connector-pins or traces.

•

If working at an anti-static workbench with professional dis-
charging equipment, please do not omit to use it.

$

$

Important!

Make connections to your CP341 only after having mounted it in a
suitable location (see section “Board Placement” of this manual).