32
33
• Shave against the direction of hair growth in order to capture the hairs
optimally.
• After shaving with the trimmers, the shortened hairs can be shaved even-
ly further with the foil shaver.
Using the foil shaver:
DANGER!
Risk of skin irritation and foil breakage!
Avoid applying excessive pressure to the skin.
• Stretch the skin of the area to be shaved (figure 1).
• Place the appliance at an angle of approx. 90° onto the skin, whereby the
switch is facing towards you (figure 1).
• Guide the appliance in circular movements over the skin (figure 2).
• Shorten the previously trimmed hairs evenly further with the shaving foil.
After use
• Particularly after first using the appliance, a slight irritation and / or
reddening of the skin may occur. This skin irritation should vanish after a
short time. If the skin irritation lasts for longer than 48 hours, then consult
a doctor.
This skin irritation can be prevented by supporting the recovery phase of
the skin with a moisturizing cream, which can be applied directly after
depilating.
Switching off
• Slide on/off switch
;
(
5
) down.
06. Cleaning and Care
• Regular maintenance and care ensure optimal results and increase the
service life of the appliance.
DANGER!
Unplug the wall power supply from the socket before
cleaning the appliance.
• Never touch the wall power supply with wet hands when plugging
it into or removing it from the socket.
• Always keep all electrical parts such as wall power supply and
connector cable dry.
• Never immerse the appliance in water or other liquids.
CAUTION! Equipment damage caused by incorrect cleaning!
Remove the shaving head and epilation head attachments from the
appliance before cleaning it.
• Do not use any aggressive or scratching cleaning products.
Cleaning the epilation head
NOTE:
• Thoroughly clean the epilation head (
3
) after each use; the tweezers can
become clogged which would result in disappointing epilation results.
1. Use your thumb and index finger to press the
epilation head frame (
2
) slightly inwards on both
sides (
▲
●
) and remove it from the epilation head.
2. Press the unlocking button (
4
) and remove the
epilation head from the appliance.
3. Use the included cleaning brush to remove all
hairs that have accumulated between the metal
and plastic parts.
4. The epilation head is easily cleaned under running water.
