Operation
20
5269
2
007
-1
2
33
Reading data on data carriers
Read data on a data carrier as follows:
1.
Select
Read/Write > Data read
.
2.
Position the read/write head on the Handheld directly beside the data carrier.
3.
Press the left softkey (
).
If the read process is successful, the status LED lights up yellow and then green. If you have
activated the buzzer and the vibration alarm in the Settings menu, an acoustic signal sounds
and the Handheld vibrates. The read data is then displayed in line with the selected data
format. If the transfer was unsuccessful, the status LED briefly flashes red and a fault indication
is issued. See chapter 8
Tip
Other options see chapter 9.1.1
Note!
All data is displayed in the data format (ASCII, HEX, DEC) selected in the Data format
submenu.