POWERSCAN
Configuration PSCAN-D-1*
49
4.7
Reading Parameters
The Default value is signed with (*).
To change the default values
1. Read the "Enter Configuration" code once.
2. Read configuration codes from the desired groups
or follow the procedure given for this code group.
3. When desired you can change further configuration codes directly.
4. Read the "Exit and Save Configuration" code once.
4.7.1
Trigger Type
Default Reading Parameter
Parameter
Default
Trigger type
Hardware trigger
Trigger signal
Trigger active level
Trigger click
Disabled
Trigger-off timeout
Disabled
Flash Mode
on 1 sec., off 0,6 sec.
Reads per cycle
1
Safety time
0.5 sec.
Beeper intensity
High intensity
Beeper tone
Ton 2
Beeper type
Monotone
Beeper length
Short
Good read spot duration
Medium
Aiming system
Disabled
Enter configuration
Exit and save configuration
Trigger Type
Software trigger
Hardware trigger (*)
always on
