IC-02.1 card capture reader
8 INSTALLATION INSTRUCTIONS
8.1 Installation details
When installing the equipment, observe precautions (see Clause 7.1).
Proper installation is critical to performance and serviceability of the card capture reader.
We strongly advise to study this section before installation work, and follow the instructions
to the latter.
Attention!
The manufacturer will not accept liability for any damage to the card capture reader
or otherwise loss caused as a result of improper installation, and will dismiss any
claims by the customer should the installation work be carried out not in accordance
with this Manual.
We recommend:
installation to be carried out by at least two persons qualified to perform assembly
and electric works;
mount the card capture reader on flat, solid concrete floors (grade 400 or higher,
SCS B22.5), stone or similar foundations at least 150 mm thick;
use reinforcing elements 300×300×150 mm for installation on less steady
foundations;
make sure the mounting foundation is horizontal and flat; the flatness deviation
must not exceed 1,5 mm;
use
“SORMAT”
anchor bolts to fix the card capture reader.
8.2 Installation tools
We advise to use the following tools for the installation work:
hammer drill 1.2
1.5 kW;
16 mm,
30 mm hard-alloyed drill bits;
S8
hexagon wrench;
cross-head screwdriver No. 2 (150mm);
knife;
measuring tape (1 m);
level
gauge.
Note:
Other tools can be used that don’t deteriorate the quality of installation work.
8.3 Cables parameters
The cables used for connection of the card capture reader are given in Table 1.
Table 1. Recommended cable types
№
Connection
Max.
length, m
Cable type
Example
1
IC-02.1 –
power supply
30
50
Twisted pair cable with
cross section min. 0.75 mm
2
AWG 18; HO3VV-F 2×0.75 bi-
coloured
2
IC-02.1 – ACS
controller
50
24AWG – 18AWG
( 0,2 - 0,8 mm
2
)
RAMCRO SA82BI-T, W8ekw
CABS8/EC, 8C.SEC-SC,
3
Reader board –
ACS controller
50
Twisted pair cable, min.
Cat5
2×2×0,52, F/UTP2-Cat5e
11
