IC-02.1 card capture reader
10 POWER-UP
1. Connect power supply unit to the mains with voltage and frequency given in its
Certificate.
2. Switch on the power supply unit.
3. The indication module will light up in accordance with operating mode set by ACS
controller.
4. Check operation of the card capture reader together with the ACS controller in all
modes according to the operation algorithm (see Clause 11.1, 11.2).
11 OPERATION INSTRUCTIONS
Attention!
When operation the equipment, observe precautions (Clause 7.2).
Warning!
Don’ts:
dismantle and/or adjust operational units of the card capture reader;
clean the card capture reader with substances that may cause damage or
corrosion;
keep the card capture reader out of jerking and thrusting.
At the standby state the ACS controller is switched into “Control” mode and blocks the
operating device. Control over indication of the built-in reader inside the card capture
reader is made by the ACS controller and the yellow LED indicator lights up on the
indication module.
On leaving the site visitors and employees present their cards to the card capture reader.
Code reading is confirmed by momentary change of yellow LED indicator and sound
signal.
11.1 Presenting a quest card
The guest card is presented by inserting it into the slot of the card container.
At the guest card presentation, considering that card is operative and its validity
corresponds to the time of passage, the ACS controller sends a signal to the card capture
reader to capture the card and switches into the
“Verification”
mode. The simultaneous
blinking of green and red LED indicators is present on the indication module at that.
In case of the ban on passage (card fault, card invalidity corresponding to the time of
passage or access wright) the ACS controller does not switch to
“Verification”
mode. The
red indicator and sound signal is switched on for 2 sec. on the indication module at that.
After that the ACS controller blocks the operating device and switches back to the
“Control” mode.
Being in the
“Verification”
mode the ACS controller receives the “Card captured” signal at
the card falling into the card container. After receiving this signal the ACS controller will
unblock the operating device for the time set by its
Passage waiting time
parameter. The
green indicator on the indication module showing authorization of passage is switched on
at that.
After the passage through operating device is made or its
Passage waiting time
is lapsed
the ACS controller switches back to the “Control” mode and blocks the operating device.
17
