Assembly and Operation Manual
10
5.2.1 Section
Each section is a single piece of equipment. There are two glass covers (3) that cover the top of
the section. There is a central insert with grooves for the sliding panel (sliding panels) and for the
filling glass located between the glass covers on top of the section. The fixing points of the sliding
panels (1) and filling glass (2) to sections are covered by side panels (6) from two sides.
ST–02
has side panels of two types-one is solid and one with a groove for the sliding panel, both side
panels of the
STD-02
double-sided section have grooves for the sliding panels.
The upper indication block (5) is built into one of the glass top covers at the front end of the section
(double-sided section features two upper indication blocks in both top covers), which includes an
indicator of the passage granting (green arrow), an indicator of the passage denial (red cross) and
an indicator of the card interrogation zone ("hand with a card" pictogram).
The section front ends are covered with front end panels made of stainless steel (7). There is a
front end indication block (8) located on one of the front end panels (7) that indicates the passage
direction or the passage denial (white arrow or red cross). Both front end panels of the double-
sided section are equipped with indication blocks.
The sliding panel (1) is driven by a mechanism that is equipped with an electric drive and located
inside the section.
There are two levels of passage sensors on the sides of the section – the lower one (14) and upper
one (15) – are located under the plastic inserts and provide the passage control.
The
ST02.-30.771
control board (hereinafter –
control board
) is installed under one of the glass
covers of the
Master
section (section side), see Fig. 20. Power supplies, RC-panel
(WRC-receiver),
Fire Alarm
device and, if necessary, other optional equipment, as well as
connection cables from the
Slave
section (section side) are connected to the control board through
the remote terminal block (Fig. 7).
5.2.2 Indication blocks
The following indication blocks are installed on each speed gate section:
•
Upper indication block (5) is installed on one of the glass top covers (
STD-02
– on both section
top covers). It includes a white indicator (hand with a card) that indicates card interrogation
zone, a green indicator (arrow) that lights up when the passage is allowed in this direction, and
a red indicator (cross) that lights up when the passage is denied:
–
authorized passage green indicator
– passage denial red light
–
card interrogation zone white indicator
•
The front end indication block (8) on the front end panels is designed to indicate the passage
direction through the speed gate. It constantly displays
−
either a white arrow or a red cross:
– passage denial red light
– passage direction white indicator
