ST-02 Speed gate and STD-02 Double-sided section
3
Dear customers!
Thank you for purchasing PERCo product.
Please follow instructions given in this Manual carefully and this high quality product
will provide many years of trouble-free use.
Assembly and operation manual for the
ST-02
speed gate
and
STD-02
double-sided section
(hereinafter –
the Manual
) contains the instructions on safe transportation, storage, installation,
operation and maintenance of the above mentioned products. The installation must be carried out
by qualified installers in strict accordance with the Manual.
Abbreviations adopted in the Manual:
PS – power supply;
RC-panel – remote control panel;
WRC – wireless remote control;
ACS – access control system;
Due to continuous improvement of products the Manufacturer reserves the right to modify, without
notice, the product design not aggravating its technical specifications.
1 APPLICATION
ST-02
Speed gate
(hereinafter –
the speed gate
) is a blocking device with sliding panels and is
designed for pedestrian passage control at entrance points of administrative buildings, banks,
shops, railway terminals, airports, etc. The speed gate produced in two versions:
ST-02.600
with
passage width of 600 mm and
ST-02.900
with passage width of 900 mm.
The speed gate consists of two sections
ST-02.600/M
(
ST-02.900/M
) (hereinafter –
Master
section) and
ST-02.600/S
(
ST-02.900/S
) (hereinafter –
Slave
section). The speed gate standard
delivery set allows organizing one passage lane.
In order to increase the number of passage lanes, it is necessary to purchase
STD-02
double-sided sections
(hereinafter –
double-sided section
). Each double-sided section allows you
to organize one extra passage lane. The double-sided section has two main versions:
STD-02.600
for the organization of passageways with a width of 600 mm and
STD-02.900
for the
organization of passageways with a width of 900 mm.
In order to organize a checkpoint with passage lanes of different widths (600 and 900 mm) it is
necessary to use
ST-02.600/900
version (includes
Master
and
Slave
sections with panels of
different widths that can be supplied on a separate order), and
STD-02.900
double-sided section
can be configured so to reduce the extended panel width for the 600 mm-wide passageway.
Note:
It is possible to install access card reader inside of the speed gate sections that are
produced by
PERCo
(
IR03.1
,
MR07 OEM
,
RP-15.2
) and third-party manufacturers. Access
card readers are not included in the standard delivery set
!
Selection of the reader and its
installation into equipment is performed by the customer (installer) in accordance with the
checkpoint project and ACS and controller characteristics. Readers must meet the following
requirements:
overall dimensions ............................................................................ max. 230×72×32 mm
passage sensor reading range ........................................................................ min. 40 mm
Also, it is possible to install the ACS controller inside the speed gate section. Dimensions
are limited to ...................................................................................... max. 160×140×40 mm
2 OPERATING CONDITIONS
The product, with regard to resistance to environmental exposure, complies with GOST15150-69
category NF4 (operation in premises with climate control).
Operation of the speed gate is allowed at ambient air temperature from +1°C to +50°C and relative
air humidity of 80% at +25°C.
