PERCo TTR-04CW-24, Assembly And Operation Manual

Assembly and Operation Manual 

12 

6  MARKING AND PACKAGING 

The turnstile has the following marking: 



  on the turnstile housing — a label located inside on the side of the turnstile housing (to 

get access to the above label unscrew the fixture bolt close to the lock (10) with a 

socket wrench S10 and carefully lift the cover up with the LED indication display (12)). 



  on the CU — a label located on the back panel of the control unit. 

The complete delivery set of the turnstile (Chapter 4.1) is packed in a transportation box to 
keep it undamaged during transportation and storage. 

7 SAFETY REQUIREMENTS 

7.1  Installation safety requirements 

The installation should be carried out only by qualified personnel who has taken safety 
training and has carefully studied this Manual. 

Warning! 



  Use only the serviceable tools for installation. 



  Observe general electrical safety rules when laying out the cables. 



  All the connectors should be connected up when the CU is switched off from the 

AC mains. 

It is prohibited: 

to mount the control unit on the current-conducting surfaces or install it in wet 
premises. 

See certificates of the power supply units for the safety requirements to those power 
supply units

. 

7.2  Operation safety requirements 

Observe general electrical safety rules when operating the turnstile. 

Do not use! 



  Do not use the turnstile under conditions that do not comply with the 

requirements of Chapter 2 of this Manual. 



  Do not open the CU cover prior to the power supply switching off. 



  Do not replace the fuses prior to the CU power supply switching off. 



  The turnstile operates within voltage range from 198V AC to 242V AC only. In 

case of jumps in voltage exceeding the operating voltage range, use a voltage 
stabilizer.