TTR-08A Electromechanical Tripod Turnstile
Figure 10. Floor anchor position and cable entries for housing installation
(turnstile housing is dotted)
Figure 11. Turnstile with cover removed
1 – reinforcement plate; 2 – fixing screws of reinforcement plate;
3 – turnstile housing; 4 – back panel; 5 – readers installation place
8. Remove the back panel of the turnstile. To do so move it up along the turnstile
housing until it is unengaged from the housing. The back panel is equipped with two
pairs of engagement grips located on its upper and lower part.
Caution!
Fix the housing after laying the cables in the electric raceway and inside the
turnstile housing. Be careful and prevent the turnstile from falling before it is fixed.
9. Lay the cables in the electric raceway and inside the turnstile housing.
19
Summary of Contents for TTR-08A
Page 34: ...www perco com...
