PERCo TTR-08A, Assembly And Operation Manual

TTR-08A Electromechanical Tripod Turnstile 

9  OPERATION INSTRUCTIONS 

Follow the turnstile operation safety requirements (see Clause 7.2 

«Operation safety 

requirements»

. 

It is prohibited! 



  To move through the turnstile passage area any objects with dimensions 

exceeding the width of the passageway. 



  To jerk hit barrier arms, turnstile housing and light indication display so as to 

prevent their mechanical deformation. 



  To disassemble and regulate turnstile components. 



  To use abrasive or chemically active substances for cleaning of the turnstile 

external surfaces. 

9.1  Power-up 

Follow these steps: Power-up 

1.  Connect the AC power cable (8) of the turnstile power supply (9) to the AC outlet 

with the voltage and frequency rating according to the certificate for power supply. 

2.  Switch on the turnstile power supply (9). At the set pulse control mode, the turnstile 

switches to 

«Always locked»

 mode. At the set potential control mode, the turnstile 

switches to 

«Both directions locked»

 mode. At the same time the red LED indication 

of the turnstile cover showing the ban on passage and the indicator above the 

STOP

 button on the RC panel (13) light up. 

3.  Lift up the barrier arm (3). It will be fixed automatically.  
4.  Check operation of the intrusion detector and siren (if included in the delivery set 

and installed accordingly). After the power-up wait until the moment of the test 
indicator (inside the intrusion detector) going off (from 10 to 50 sec). Put your hand 
before the intrusion detector. The continuous signal will sound when the intrusion 
detector activates. To eliminate that sound signal press any button on the RC panel. 
The sound will stop without pressing the button in 5 sec.  

The turnstile is ready for operation. 

9.2  Operating modes of the turnstile at pulse control mode 

After switch on the power supply the turnstile is automatically switched to 

«Always locked»

mode. 
See Table 3 for the operating modes set from the RC panel and for the corresponding 
indication. Setting the operating modes for each direction is independent, i.e. setting the 
operating mode for one direction does not change the operating mode set earlier for the 
opposite one. 
The RC panel overall view is given in Fig. 3.   



 The 

“Single passage in the set direction”

 mode can be changed to the 

“Always free”

mode for the same direction, or to the 

“Always locked”

 mode; 



 The 

“Free passage in the set direction”

 mode can be changed to the 

“Always 

locked”

 mode only. 



 In the 

“Single passage in the set direction”

 mode the turnstile will close 

automatically after a person’s passage in the set direction. The turnstile will also 
close automatically, if the passage is not made within 5 sec.  



 In 

the 

“Bi-directional single passage”

 mode after the passage in one direction the 

countdown of the passage waiting time (5 sec.) for the opposite direction is 
recommenced. 

23