TTR-10A electromechanical tripod turnstile
Indication on
Operating
modes
Actions to do on
RC-panel
RC-panel
Turnstile status
LED display
“Single passage
in the set
direction”
Press the
LEFT
/
RIGHT
button.
The green
indicator “
Left”
/ “
Right”
is on.
Green arrow for the
chosen passage
direction is on.
The turnstile is
unlocked for a
single passage in
the set direction. In
the other direction,
the turnstile
remains blocked.
“Bi-directional
single passage”
Press both the
LEFT
and
RIGHT
buttons
simultaneously.
Both green
indicators
(
“Left”
and
“Right”
) are
on.
Green arrows for both
passage directions are
on. After the passage,
the green arrow for this
direction goes out. After
the second passage,
the second arrow goes
out and the red cross is
on.
Regardless the
order of passage,
the turnstile is
unlocked for
sequential single
passage in both
directions.
“Free passage in
the set direction”
Press the
STOP
button and
LEFT
or
RIGHT
simultaneously.
The green
indicator of the
chosen
passage
direction
“Left”
/
“Right”
is on.
Green arrow for chosen
direction is on.
The turnstile is
unlocked for
passage in the set
direction. In the
other direction, the
turnstile remains
blocked.
“Free passage in
the set direction
and single
passage in the
opposite
direction”
Set the “
Free
passage in the set
direction”
mode for
one direction and
“
Single passage in
the set direction”
for the other.
Both green
indicators
(
“Left”
and
“Right”
) are
on.
Green arrows for both
passage directions are
on. After the passage,
set for single pass,
green arrow goes out.
The turnstile is
unlocked for free
passage in the set
direction. In the
other direction, the
turnstile unlocks for
a single passage.
“Always free”
Press all 3 buttons
simultaneously:
LEFT, STOP and
RIGHT.
Both green
indicators
(“Left” and
“Right”) are
on.
Green arrows for each
passage direction are
on.
The turnstile is
unlocked in both
directions.
9.3 Operating modes of the turnstile at potential control mode
See Table 6 for the turnstile control modes and indication. Setting the operating modes for each
direction is independent, i.e. setting the operating mode for one direction does not affect the
operating mode for the opposite one.
If by the moment of passage through the turnstile the low level is present on the contact,
corresponding to the set passage direction, the turnstile remains open in the set direction.
Table 6. Potential control mode (no J1 jumper)
Indication on
Operating
mode
Operating signal
RC-panel
Post
Turnstile status
“Both
passage
directions
are locked”
The high level on
contacts
L
and
R
or
low level on “
ST”
contact
.
Red indicator
“
Stop”
is on.
Red crosses for each
passage direction are
on.
The turnstile is locked.
27
