T
В
-01 Electromechanical box tripod turnstile with two built-in readers
7
Figure 2 – Overall dimensions of the T
В
-01 turnstile
6.2.5 The CLB (Ref. Fig. 3) houses:
“X1” (Control) connector to connect the control mechanism (connected to
the “X1” connector of the control mechanism with the turnstile cable);
“XT1.L” (In) connector block to connect the RC panel /the wireless remote
control/ACS controller inputs as well as an emergency unblocking device;
“XT1.H” (Out) connector block to connect a siren and outputs, providing the
turnstile status data to the ACS controller;
“XT2” connector block (Detector) to connect an intrusion detector;
“XT3” (+12VDC) connector block to connect the turnstile power supply;
“XT4” (Light A) and “XT5” (Light B) connector blocks (at delivery indication of
top cover card readers is connected to the connector blocks);
J1 connector to select the turnstile control mode;
J2 connector for programming.
6.2.6 The T
В
-01 turnstile is powered via a power cable (18). As power supply it is
recommended to use 12 VDC power supply with linear stabilization of voltage
and pulsation amplitude at output not exceeding 50 mV. Value of output
current should be minimum 1,5
А
.
Summary of Contents for Turnichetul TB 1
Page 37: ...www percoweb com...
