EHS400D
00 (23/02/2012)
4
Re-apply mains power to the device.
6.
Configuration
To configure the detector settings, turn switch LUX (
C
) clockwise till the end and switches SENS (
A
)
and TIME (
B
) counter clockwise till the end. These switches are located at the bottom of the detector
First set the detection field by moving the detector up-down and/or left-right. Walk around in the
detection field to determine the boundaries.
Configure the speed with which movements are detected, by turning the movement sensitivity switch
(
A
) clockwise. Test by walking through the detection field at different speeds.
Configure the time that the halogen spot has to be operational after detecting movement by turning
the time switch (
B
) clockwise.
For the setting of the light sensitivity, turn the light sensitivity switch (
C
) counter clockwise till the end
(towards moon). Wait until darkness sets in, and at the preferred light condition, turn the light
sensitivity switch (
C
) clockwise while creating movement in the detection field until the spot switches
on.
7.
Service
There are no user-serviceable parts.
Contact your dealer for spare parts if necessary.
8.
Technical specifications
Lamp max.
voltage
230V
AC
maw. power
500W
IR detector
Detection angle
180°
Detection distance
10 ± 2m
working temperature
-10°C ~+40°C
Time delay
10±5s ~ 7±1min (adjustable)
Installation height
2 ~ 4.5m
Use this device with original accessories only. Velleman nv cannot be held responsible in
the event of damage or injury resulted from (incorrect) use of this device. For more info
concerning this product, please visit our website www.perel.be. The information in this
manual is subject to change without prior notice.
A.
Movement sensitivity switch
B.
Time switch
C.
Light sensitivity switch
