TC84100N
V. 04
–
10/03/2022
5
©Velleman Group nv
Exchanging Wicks
1.
Loosen the three fixing nuts and remove
the guard frame. Remove the chimney.
2.
Loosen the four fixing nuts and remove
the wick cover. Make sure not to lose the
packing.
3.
Loosen the nut for the wick adjusting
handle by turning it to the left. Pull the
wick adjusting handle towards you.
4.
Pull up the wick holder together with the
wick. Remove the old wick from the wick
holder. Clean the wick guide, burner
cover, etc.
5.
Insert a new wick inside the wick holder
and fix it with the hooks on the inside of
the wick holder. Make sure to expose an
even amount of wick on both sides of the
wick holder. Slide the wick holder over the
wick guide.
6.
Get the wick holder in gear with the tip of
the wick adjusting handle. Turn the wick
adjusting handle to the right and lift the
wick fully. Make sure not to fasten too
tightly. If the top of the wick is not evenly
exposed, even out with a scissor. Put the
wick cover on the burner. Make sure the
gap between the wick cover and the wick
guide is even. Test the heater before
actually using it.