Installation and Operation Manual for the
Perenio®
PEACG01 Control Gateway
Doc Version: 2.0.0
©Perenio IoT spol s r.o. All Rights Reserved
Page
18
of
32
B.1.
MANUAL ACTIVATION OF THE DEVICE
If the QR Code was damaged or lost, you can enter the
device data manually as follows:
a.
Click on the ENTER MANUALLY button at the bottom of
the QR Code scan screen (See the figure in par.
B
);
b.
Enter the Device ID and the Password specified in the
Quick Start Guide or on the bottom of the device
(ID and Password lines next to the QR Code);
c.
Click on the CONNECT button.
C
.
SENDING WI-FI NETWORK DATA TO THE DEVICE
Do as follows after the screen to connect the device to the
Wi-Fi Network will be displayed:
a.
Enter the password from the Wi-Fi Network or select
another Network
;
NOTE.
The device may be connected to
Wi-Fi Network of
2.4 GHz
only.
b.
Click on the
CONNECT button.
NOTE.
Before connecting, make sure that the CG is
powered on and that the smartphone is located at a
distance of not more than 2 meters from it.
If the Wi-Fi Network password is incorrectly entered more
than twice in a row, the Control Gateway may not return
to the Access Point mode, which means that the reset to
factory settings will be required (See par. 2.2 below).
