8
DOOR ALIGNMENT
&
REVERSAL INSTRUCTIONS
1.
Remove the top hinge cover.
2.
Using Phillips Head Screwdriver, loosen and remove the screws holding the top hinge in place.
3.
Remove top hinge and carefully lift off the door.
4.
Remove the screw hole plugs from the opposite side and insert the plugs in the screw hole openi ngs
of
the just removed screws.
5.
Remove any loose items from the refrigerator; Carefully turn refrigerator on its back
and place in a
secure area
.
6.
Loosen the screws holding the lower hinge bracket to the refrigerator and remove screws and bracket.
7.
Remove (2) screws from the other side and insert in the previously removed screw holes.
8.
Remove door pin by turning it counter-clockwise
, then
reinsert
in
to the underside of the bracket
and tighten.
9.
Align bracket and insert (2) remaining screws into the holes provided.
10.
Align hole in the door with the door pin and washer and gently push down until firm.
11.
Align upper hinge bracket with screw holes
.
I
nsert screws and partially secure
. C
heck that door an d
cabinet are properly aligned and then secure tightly.
12.
Replace hinge cap.
1.
Remove the top hinge cover by using a flathead screwdriver. Place
the head under the front edge of the cap and gently lift.
(Fig. 4)
2.
Loosen the top hinge screws using a Phillips head screw driver.
3.
Adjust the door or put a spacer in between and tighten the screws.
4.
Replace the top hinge cover by aligning the rear of the cover with
the rear of the hinge. Press firmly on the front of the cover until it
snaps in place.
Door Alignment
Fig.
4
Door
Reversal
(Fig. 5)
Fig.
5
NOTE
:
As the door gets pressed in during
shipping, after reversing the door,
the gasket may have to be reset.
This is done to prevent the cool
refrigerated air from escaping. If
there is a gap between the door
gasket and the cabinet, set the
gasket by gently pulling it out to seal
the gap.
Summary of Contents for 3W1BF32
Page 15: ......
