Parts Included:
2
- Assembled Leg Sets
1
- Table Top
1
- Hole Plug
4
- Leg Braces
ASSEMBLY INSTRUCTIONS
Bistro Counter Height or Bar Height Table
Tools Not Included but Required:
7/
1
6" wrench, either a power tool, hand driver or ratchet
wrench that will accept a
1
/4" hex drive bit.
Tools Included:
4mm Allen Wrench
Stainless Steel
Hardware Included:
8 - 3" Lag Screws
8
-
1
-
1
/2" Screws
8 - Washers
1
. Position the leg sets upside down with the feet in the air and the leg notches facing inward. Place a leg
brace into one of the lower notches of both leg sets. Screw in a 3" lag screw only part way, into both let sets.
Repeat this step and insert the other leg brace into the other lower set of notches. Screw in a 3" lag screw
only part way into both let sets.
Step
1a
Table Top
Leg Braces
Assembled Leg Sets
Hole
Plug
Hardware
2. Repeat step
1
and insert the upper braces. After inserting all 4 braces, tighten all screws.
Step
1b
