Selecting a DAB radio station
When playing a DAB radio station, the display normally shows the name of the current
station with other related information.
Rotate the
Tuning/Seek/Select control
to access the radio station list and to scroll
through the available stations.
Press the
Tuning/Seek/Select control
to select the highlighted station. The display may
show 'Connecting...' while the radio re-tunes.
Use the
Volume control
to set the sound level as needed.
Note:
If the display shows 'Station Not Available' it may be necessary to relocate
Perfectpro Audisse to a position giving better reception.
A question mark in front of the station name merely indicates that the station has not
recently been detected by the sound system. It may still be available.
FM RADIO
Operating in FM mode
Carefully adjust the rod antenna and press the
Power button
to switch on Perfectpro
Audisse.
Press the
Source button
as needed to select FM radio mode.
Rotate the
Tuning/Seek/Select control
in a clockwise direction. The displayed
frequency will increase. Press the
Tuning/Seek/Select control
to carry out an auto-
tune. Your radio will scan up the FM band from the currently displayed frequency and
will stop scanning when it finds a station of sufficient strength.
The display will show the frequency of the signal which has been found. If RDS
information is available, after a few seconds the display will show the radio station name.
If you only hear hiss or interference, simply press the
Tuning/Seek/Select control
to
scan further. Perfectpro Audisse may have found a spurious interference signal.
GB
23
24
