Coax against
the stop
90°
Cut the end of the
cable cleanly with
sharp cutters at a
90° angle.
Insert the coax into the
appropriate
cable prep tool so
the end of the coax is flush against the stop.
Turn the prep tool five or six full and continuous revolutions
around the coax. Do not reverse the direction of the turn, it
is unnecessary and can damage the braid.
1
3
2
4
It is important to make sure
ALL the braid wires are
folded back neatly.
Do not nick or cut through these wires
The two cutoff
sections should
be 1/4" and
5/16" long.
Remove the foil layer.
Cutoffs should be 1/4” and
5/16” long.
Fold ALL braid wires
back neatly.
Nick the foil close to the
PVC jacket and begin
peeling the foil.
0.25”
0.25”
0.3125”
0.3125”
Nick Foil
Nick Foil
4
4
DUAL SHIELD
TRI-SHIELD
QUAD-SHIELD
Fold back the first
layer of braid wires.
Peel off the foil layer.
Fold ALL braid wires
back neatly.
Nick outer foil as shown.
©2016 PerfectVision Manufacturing
5 - 6
ROTATIONS
PV6UE-05
Installation Guide
U.S. Toll Free 1.866.470.0887
Interna1.501.955.0032
www.perfect-vision.com
PV6UE-05-Install_12162016_ALB
