SAFETY GUIDELINES / DEFINITIONS
UNPACKING AND INSPECTION
WARNING. READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS BEFORE
OPERATING THIS PRODUCT. FAILURE TO DO SO MAY RESULT IN FIRE, ELECTRICAL SHOCK, PERSONAL
INJURY AND/OR PROPERTY DAMAGE AND WILL VOID WARRANTY.
WARNING: Read and understand this entire instruction manual before attempting to assemble, install, operate or
maintain this product. Failure to comply with the instructions may result in serious personal injury and/or property
damage!
The following signal words are used to emphasize safety warnings that must be followed when using this product:
This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and troubleshooting steps
described within to ensure your safety and satisfaction. The contents of this instruction manual are based upon the latest product information
available at the time of publication. The manufacturer reserves the right to make product changes at any time without notice.
DANGER Indicates an imminently hazardous situation that, if
not avoided, WILL result in death or serious injury.
WARNING Indicates a potentially hazardous situation that, if
not avoided, COULD result in death or serious injury.
CAUTION Indicates a potentially hazardous situation that, if
not avoided, MAY result in minor or moderate injury.
NOTICE Indicates important information, which if not followed,
MAY cause damage to equipment.
After opening the carton, unpack your new product and related parts & accessories. Please inspect it carefully for
any damage that may have occurred during transit. Please check it against the photograph on carton.
WARNING DO NOT operate this product if damaged during shipment, handling or misuse. Do not operate the product until the
parts have been replaced or the fault rectified. Failure to do so may result in serious personal injury or property damage. All damaged
parts must be repaired or replaced as needed prior to operating this product. Check to see that all nuts, bolts and fittings are secure
before putting this product into service.
Please have the serial number, model number, and date of purchase available for reference when calling.
2
IMPORTANT SAFETY INFORMATION
• The W1665 Jump-starter, must only be used for its intended purpose. Follow the guide lines of this instruction manual.
• This product should never be used in a commercial environment
• Check the rating plate to ensure that the correct input voltage is being supplied to the product.
• Always switch the product OFF and remove the plug from the wall socket when not in use and before cleaning or changing
accessories.
• Always ensure the product is switched off before changing batteries.
• Never reach for electrical product that has fallen into water, this will result in an electric shock.
• Disconnect the plug from the wall socket before attempting to remove it from the water.
• After removal, never attempt to re-connect the Jump-starter until it has fully dried and has been tested and approved by a
qualified person.
• Designed to be used by responsible adults. Ensure all instructions and safety precautions are reviewed and adhered to.
NOT for use by children!
• Never allow the cables to come into contact with a heat source, water or any other liquid.
• Prevent sharp objects from coming into contact with the cables when the Jump-starter is in use.
• Never allow the cables of the Jump-starter to drape over the edge of a work surface where it could be pulled by a small
child.
• Always check the position of the cables when the Jump-starter is in use and use cable restraints when provided.
• Never carry the Jump starter by the cables as it could cause damage resulting in electrical failure when next used.
• Never operate this product if the cable or plug, become damaged. NOTE: Only a qualified person can carry out repairs on
this item.
• Be aware that electrical products become hot during use. Never touch hot surfaces during use and ensure all users are
informed of the risks. Use an oven glove where required.
• Where relevant, keep all ventilation slots clear from obstructions and observe safe working distances from walls etc. Never
put anything into the ventilation slots of an electrical appliance.
• Never operate this product with wet hands. Always ensure your hands, the Jump-starter and work area, are dry before
moving forward with connections.
• If this product stops working unexpectedly, switch off and unplug the product immediately. Seek professional advice before
attempting to re-use the product.
