www.performaracing.com 13
Drag Brake Rate
Sets the rate at which the drag brake is applied until it
reaches the pre-set value. A lower value causes the car to
slow down more smoothly and a higher value causes the car
to stop more abruptly.
You can also set a lower value to prevent load and wear on
the drivetrain if your car is reaching higher speeds.
Low voltage cut-off
This function helps to prevent battery over-discharge. If
the battery voltage becomes lower than the threshold for
2 seconds, the output power is shut off and the red LED
flashes. The cut-off threshold calculation is based on LiPo
individual cell voltage. For NiMH batteries, if the voltage
battery pack is higher than 9.0V, it will be considered as
a 3 cell LiPo battery pack; if it is lower than 9.0V, it will be
considered as a 2 cell LiPo battery pack.
Start mode “Punch”
Sets the initial throttle punch when the car accelerates.
Level 1 gives a very soft initial acceleration and level 9 gives
a very strong initial acceleration. A lower setting can help to
improve traction.
Max Brake Force
Sets the maximum braking force. If you want to run your car
like a normal car (the car rolls when you release the throttle)
you can disable or decrease the drag brake and use regular
braking to slow down the car instead.
Note: stronger brakes cause more load on the drivetrain
and heat output will be increased, use with caution.
Summary of Contents for Crawler Combo
Page 1: ......
Page 7: ...www performaracing com 7 ...
Page 8: ...8 Copyright Performa Racing 2019 PROGRAMMING YOUR ESC ...
Page 16: ......