SPECIFICATIONS
Specifications are subject to change without notice
IMPORTANT SAFETY INFORMATION
WARNING!
READ, UNDERSTAND AND FOLLOW ALL INSTRUCTIONS AND WARNINGS
BEFORE OPERATING THIS TOOL. FAILURE TO DO SO MAY RESULT IN
PERSONAL INJURY AND/OR PROPERTY DAMAGE AND WILL VOID WARRANTY.
1. Keep work area clean. Cluttered areas invite injuries.
2. Observe work area conditions. Do not use machines or power tools in damp
or wet locations. Don’t expose to rain. Keep work area well lighted. Do not
use electrically powered tools in the presence of flammable gases or liquids.
Do not bring combustible materials near the tools.
3. Keep children away. Children must never be allowed in the work area. Do not
let them handle machines, tools, hoses or extension cords.
4. Store idle equipment. When not in use, tools must be stored in a dry location
to inhibit rust. Always lock up tools and keep out of reach of children and
other untrained persons. Switch off all unused electrical tools when stored.
Tools are dangerous in the hands of untrained users.
5. Always wear approved eye protection when using tools. If raising dust, wear
a suitable mask.
6. Work Safe. Do not wear loose clothing or jewelry that could become caught
by moving parts, causing injury. Operate tool a safe distance from yourself
and others in the work area. Keep proper footing and balance at all times. Do
not reach over or across running machines, hoses, etc.
7. Do not operate any tool if under the influence of alcohol or drugs. Read
warning labels on prescriptions to determine if your judgment or reflexes are
impaired while taking drugs. If there is any doubt, do not operate any tool.
8. Be sure air is in OFF position when connecting tool to air supply.
9. Use only those accessories that are designed for use with tools. For exam-
ple, with impact wrenches do not use ordinary sockets. Use impact sockets
for all air tools.
10. Be sure to disconnect tool from air supply before changing accessories,
performing service on tool and when not in use.
Drive Size (IN.) .................................................................................... 3/8
Max torque (Ft/Lbs) ........................................................................... 180
Working torque (Ft/Lbs) ................................................................50-100
Free Speed (RPM) ........................................................................ 10,000
Avg CFM ............................................................................................. 2.5
Air Inlet (NPT) ................................................................................. 1/4 in.
Standard bolt size ......................................................................... 1/2 in.
Weight (LBS) ....................................................................................... 2.9
Warning!
Oil tool before each use. 4 to 5 drops of a good grade Air Tool Oil placed in the
air inlet is sufficient. Use proper air pressure and CFM rating listed for this tool.
# Description
Qty.
#
Description Quantity
PARTS LIST
1 Housing
1
2 Back Plate
1
3 O-Ring
1
4 Reverse Valve Sleeve
1
5 Reverse Regulator
1
6 Spring
1
7 Steel Ball
1
8 Straight Pin
1
9 Bushing
1
10 Valve Seat
1
11 Taper Spring
1
12 Exhaust Deflector
1
13 Air Inlet
1
14 Trigger
1
15 Regulator Knob
1
16 Screw
1
17 Pin
1
18 Sealing Gasket
1
19 Retainer Ring
1
20 Bearing
1
21 Rear Cylinder Cover
1
22 Cylinder
1
23 Rotor
1
24 Blade
6
25 Front Cylinder Cover
1
26 Bearing
1
27 Gasket
1
28 Hammer Cage
1
29 Hammer Dog
1
30 Pin
2
31 Anvil
1
32 O-Ring
1
33 Retaining Ring
1
34 Bushing
1
35 Sealing Gasket
1
36 Hammer Housing
1
37 Washer
1
38 Screw
1
2
5
