Performax 207-9002, Owner'S Manual

26

FINISH NAIL GUN

MAINTENANCE

LUBRICATION

The tool requires lubrication before using the tool for the 
first time and before each use. If an inline oiler is used, 
manual lubrication through the air inlet is not required on a 
daily basis.

1)  Disconnect the air supply from the 

tool to add lubricant.

2)  Turn the tool so the air inlet is facing 

up. Place 4-5 drops of 30 W non-
detergent oil into air inlet. Do not 
use detergent oils, oil additives or air 
tool oils. Air tool oils contain solvents 
which will damage the tool’s internal 
components.

3)  After adding oil, run tool briefly. 

Wipe off any excess oil from the cap 
exhaust.

   NOTICE:

The work surface can become damaged by excessive 
lubrication. Proper lubrication is the owner’s responsibility. 
Failure to lubricate the tool properly will dramatically 
shorten the life of the tool and void the warranty.

After use, always store the pneumatic tool in a dry, clean 
environment. Do not use solvents, flammable or toxic 
liquids for cleaning.

   WARNING:

FASTENER AND REPLACEMENT PARTS

Use only genuine 16 gauge fasteners (or equivalent). 
Fasteners not identified for use with this tool by the 
tool manufacturer are able to result in a risk of injury to 
persons or tool damage when used in this tool). Tool 
performance, safety and durability could be reduced if 
improper fasteners are used.
When ordering replacement parts or fasteners, specify 
by part number.

TOOL REPAIR

Only qualified personnel should repair the tool, and they 
should use genuine replacement parts and accessories, 
or parts and accessories which perform equivalently.