Error Messages
271
07
Ids 1 out of
level 3
window
The drain to source
current across the
power FET transistor
1 is out of the level 3
Tolerance window.
Contact PerkinElmer Service.
08
Ids 2 out of
level 3
window
The drain to source
current across the
power FET transistor
2 is out of the level 3
Tolerance window.
Contact PerkinElmer Service.
09
Ids 1 higher
than ids
maximum
The drain to source
current across the
power FET transistor
1 is higher than the
maximum allowable
current.
Contact PerkinElmer Service.
10
Ids 2 higher
than ids
maximum
The drain to source
current across the
power FET transistor
2 is higher than the
maximum allowable
current.
Contact PerkinElmer Service.
11
Failed to
reach/
maintain
power at
specified
level
Failed to set power to
a value specified in
the Plasma Controls
Dialog window.
Contact PerkinElmer Service.
12
Failed to
set AUX
flow to
specified
level
Failed to set AUX to
a value specified in
the AUX Setting
Flow Controls
window.
Check argon supply, argon pressure, AUX
flow tubing and connections. If this does not
correct the problem, contact PerkinElmer
Service.
Summary of Contents for OPTIMA 8000
