42 .
RamanMicro 300 Getting Started Guide
Attaching the Illumination Source
To attach the illumination source to the illuminator module:
1.
Hold the illumination source in position against the rear of the illuminator module.
2.
Using the allen key supplied (Figure 15), fasten the two screws so that the source is
supported.
3.
Connect the black cable from the illumination source to the microscope frame.
Figure 15 Attaching the illumination source to the microscope
Screws
Power cable
Top View
Allen key
Screws
Summary of Contents for RamanMicro 300 Series
