Perle C/CM 10GRT-SFP Media Converter Module Installation Guide 11
SGMII Interface Hardware
Support (C Model only)
Both the C/CM models support a SGMII module on
the SFP interface for SFPs that require 1000 Mbps
SGMII.
For the Managed CM-10GRT-SFP the configuration
must be set within the software. Refer to the Perle
MCR-MGT
User’s Guide that came with your Perle
Management Module.
The unmanaged model the C-10GRT-SFP supports
the SGMII via the jumper setup as shown below.
The SGMII jumper is located on the outer edge, at
the midpoint of the card (P3). Jumper Pins 1 and 2
to select SGMII for port 1.